01-16-2017 11:13 AM - edited 07-05-2021 06:22 AM
Hi,
We use Flex Connect at our remote site APs.
I would like to allow L3, client roaming between Flex Connect APs on different subnets.
Is this possible?
And, what needs to needs configured on the controller side?
Thank you, Pat
Solved! Go to Solution.
01-16-2017 11:20 AM
Layer 3 roaming is not supported with a FlexConnect. Only local/bridge mode supports 3 roaming.
-Scott
*** Please rate helpful posts ***
01-16-2017 11:20 AM
Layer 3 roaming is not supported with a FlexConnect. Only local/bridge mode supports 3 roaming.
-Scott
*** Please rate helpful posts ***
01-16-2017 11:24 AM
Thanks Scott,
....so, there is no hack around this limitation? Someone told me it was possible and I have been trying to find some documentation for it.
Maybe a future feature...?
Thanks, Pat
01-16-2017 12:02 PM
Maybe, buts it's been a request for a long time.
-Scott
*** Please rate helpful posts ***
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: