cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
372
Views
0
Helpful
4
Replies
Beginner

LED flash function to identify from AP in 9800 not available?

hello together, I'm currently make a PoC with the 9800 controllers at the customer.

 

with a few hurdles, everything is going well so far.

 

I’ve seen, the feature LED flash blinking is not available on the 9800 or I dont find it?! an idea when will get available?

 

It is useful for quick troubleshootings and imageing/labeling of access Points, See attachment ;)

4 REPLIES 4
VIP Advocate

Re: LED flash function to identify from AP in 9800 not available?

What release are you running on the 9800? The 8.5 special TAC release or 8.9.x?
Maybe the other version contains it.
Reference: https://www.cisco.com/c/en/us/support/docs/wireless/wireless-lan-controller-software/200046-tac-recommended-aireos.html
Beginner

Re: LED flash function to identify from AP in 9800 not available?

The Release Gibraltar-16.10.1e ED is currently running. 


I don't think that the version that you mean (8.x), works on the new cisco 9800 controller?
VIP Advocate

Re: LED flash function to identify from AP in 9800 not available?

Sorry I forgot that it's not running WLC code but IOS XE code.



Can you try on the CLI the following:

config ap led-state flash 500 name-of-ap



This should blink the LED for 500 seconds for the selected AP.

If it doesn't work, open a TAC :) This is how to do it on the older WLCs. I don't have an 9800 for testing.



Manual: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg.pdf


Highlighted
Beginner

Re: LED flash function to identify from AP in 9800 not available?

this command is not available, all the most of commands in AirOS is in IOSXE not available..

so I think, it's not issued in this realease..
-> feature request :)
CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards