cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1399
Views
0
Helpful
4
Replies
Highlighted
Beginner

LED flash function to identify from AP in 9800 not available?

hello together, I'm currently make a PoC with the 9800 controllers at the customer.

 

with a few hurdles, everything is going well so far.

 

I’ve seen, the feature LED flash blinking is not available on the 9800 or I dont find it?! an idea when will get available?

 

It is useful for quick troubleshootings and imageing/labeling of access Points, See attachment ;)

4 REPLIES 4
Highlighted
VIP Advocate

What release are you running on the 9800? The 8.5 special TAC release or 8.9.x?
Maybe the other version contains it.
Reference: https://www.cisco.com/c/en/us/support/docs/wireless/wireless-lan-controller-software/200046-tac-recommended-aireos.html
Highlighted

The Release Gibraltar-16.10.1e ED is currently running. 


I don't think that the version that you mean (8.x), works on the new cisco 9800 controller?
Highlighted

Sorry I forgot that it's not running WLC code but IOS XE code.



Can you try on the CLI the following:

config ap led-state flash 500 name-of-ap



This should blink the LED for 500 seconds for the selected AP.

If it doesn't work, open a TAC :) This is how to do it on the older WLCs. I don't have an 9800 for testing.



Manual: https://www.cisco.com/c/en/us/td/docs/wireless/controller/9800/config-guide/b_wl_16_10_cg.pdf


Highlighted

this command is not available, all the most of commands in AirOS is in IOSXE not available..

so I think, it's not issued in this realease..
-> feature request :)