cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1538
Views
15
Helpful
8
Replies

License for 5508 and 2702 Ap

vantom85cisco
Level 1
Level 1

hi ,,

accually this is my first time to work with Cisco wireless ,i have WLC 5508 and 5 AIR-CAP2702E-E-K9 and word file have PAK for the 5508

i do not know how to start ,the main qoustion is :

1- how to add this license to WLC 5508

2- how to connect AIR-CAP2702E-E-K9 to our WLC5508

Thanks

2 Accepted Solutions

Accepted Solutions

Scott Fella
Hall of Fame
Hall of Fame

Hope this helps:

How to manage license:

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/system_management/config_system_management_chapter_011.html#ID307

Connect AP's to the 5508, you need to understand the basics design and why an AP might not join the controller:

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/119286-lap-notjoin-wlc-tshoot.html

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/70333-lap-registration.html

-Scott

-Scott
*** Please rate helpful posts ***

View solution in original post

8 Replies 8

Scott Fella
Hall of Fame
Hall of Fame

Hope this helps:

How to manage license:

http://www.cisco.com/en/US/docs/wireless/controller/7.4/configuration/guides/system_management/config_system_management_chapter_011.html#ID307

Connect AP's to the 5508, you need to understand the basics design and why an AP might not join the controller:

http://www.cisco.com/c/en/us/support/docs/wireless/5500-series-wireless-controllers/119286-lap-notjoin-wlc-tshoot.html

http://www.cisco.com/c/en/us/support/docs/wireless-mobility/wireless-lan-wlan/70333-lap-registration.html

-Scott

-Scott
*** Please rate helpful posts ***

Easiest way is to make sure that the time is set properly on the contoller or else AP's will not join.  Place the AP on the same subnet as the controller for an easy join.  Once the AP joins and downloads the code and is in the run state, then you can move the AP to another vlan.  Make sure that the AP gets an ip address also.

-Scott

-Scott
*** Please rate helpful posts ***

Many Thanks to you Scott ,i follow the instruction one by one and i added successfully ,i will procced with adding Ap to WLC .

Thanks gain for help

Glad to help.  If you run into issues, just reply to the post.

-Scott

-Scott
*** Please rate helpful posts ***

HI Scot ,

I tried all ways to connect to WLC but i think the problem is in WLC version is not compatible with 2700 series ,the current version is 7.4.110.0 and based on mention article there is  compatibility issue

http://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html

Yup... That compatibility matrix you should keep handy.  Code versions is important to make sure that AP's connect and also you will see what code is supported on them. 

-Scott

-Scott
*** Please rate helpful posts ***

Many thanks to you too ,clear steps

thanks for help

Review Cisco Networking products for a $25 gift card