License Issue | License not updated properly

[Wireless_Guy]

Hi All,

Recently I updated the license, and currently showing mismatch of licenses. Please find the output

Base AP count license shows 27 AP's supported, however " show license capacity " doesn't show the actual license. AP's are also not joining the controller.

WLC has been rebooted

=========================

Feature: base-ap-count                    

Version: 1.0

License Type: Permanent

License State: Active, In Use

License Count: 27 /23 (Active/In-use) <<<< License updated to support 27 AP's

License Priority: Medium

License Store: Primary License Storage

(Cisco Controller) >show license capacity  <<<<< Doesn't reflect 27 AP's

Licensed Feature    Max Count         Current Count     Remaining Count

-----------------------------------------------------------------------

AP Count            23                23                0                

[Flavio Miranda]

Hi @Wireless_Guy

Change the license priority to low then change to high again. If the EULA pop up accept it.  This should work.

If not, try to get some logs.

-If I helped you somehow, please, rate it as useful.-