cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
378
Views
5
Helpful
2
Replies
Highlighted
Beginner

load balancing traffic between AP 2802-series and LAN switch

I've just established etherchannel between 2802 AP and C2960S switch.

Which of such supported load-balancing modes can allow traffic balancing between two LAN ports connecting access point:

 

(config)# port-channel load-balance ?
dst-ip Dst IP Addr
dst-mac Dst Mac Addr
src-dst-ip Src XOR Dst IP Addr
src-dst-mac Src XOR Dst Mac Addr
src-ip Src IP Addr
src-mac Src Mac Addr

 

 

Everyone's tags (2)
2 REPLIES 2
Highlighted
VIP Mentor

Re: load balancing traffic between AP 2802-series and LAN switch

Suggested as per cisco standard : ( again depends on requirement - you can change and test)

 

port-channel load-balance src-dst-port

 

https://www.cisco.com/c/en/us/support/docs/wireless/aironet-3800-series-access-points/200898-Link-aggregation-on-1800-2800-3800-AP.html

BB
*** Rate All Helpful Responses ***
Highlighted
VIP Advocate

Re: load balancing traffic between AP 2802-series and LAN switch

Don't do it. The AP anyway can't reach speeds > 1 Gbps on wireless on normal circumstances, so you will not win anything by using load-balancing. Unless you can really use 2x a 160 MHz channel and you have 4 stream clients that are 160 MHz capable. Then it might be theoretically possible for it to reach > 1 Gbps peaks.

You will actually loose a switch port and have a way more complicated configuration.

 

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey

This widget could not be displayed.