cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
13620
Views
5
Helpful
4
Replies

Mobility Express don't open GUI

a6z69@yahoo.com
Level 1
Level 1

Dear Mates,

                  Kindly support me We have cisco access points 2802, But we don't have wireless controller.

                  Must transfer IOS from light weight to mobility express after we transferred and took right configuration and IP from DHCP all thing is right about configuration when we try to access GUI don't open.

after search we find this command must write at controller CLI ( config network webmode enable ) / save config .

 

Still GUI don't work any one facing this issue or have any solve.

4 Replies 4

Hay 

 

can you please attach show version

Haydn Andrews
VIP Alumni
VIP Alumni

Are you trying to access via HTTP or HTTPS? Try https://<mangement_ip_address>

 

The management address must be accessible via the wired network to work can you ping the management IP address?

Are you just getting page can not be found? Can you SSH the management IP address? 

 

Make sure you have followed all the pre-requisites steps in the deployment guide:

https://www.cisco.com/c/en/us/td/docs/wireless/controller/technotes/8-2/b_Mobility_Express_Deployment_guide/b_Mobility_Express_Deployment_guide_chapter_0100.pdf

 

 

 

 

 

 

 

 

*****Help out other by using the rating system and marking answered questions as "Answered"*****
*** Please rate helpful posts ***

Make sure you have a different IP address for controller and AP. From the controller cli, check the output of "show interface detailed management" use the command "apciscoshell" to connect to the AP console and then check the ap wired0 interface ip address using "show ip int br". If the AP is using IP address from DHCP, assign a different ip address to controller management interface by using command below:
(Cisco Controller) >config interface address management <IP-address> <netmask> <gateway>

jagan.chowdam
Level 4
Level 4

If you are using HTTPS to access the controller, you need to enter the following CLI command:

"config network secureweb enable"

This command allows users to access the controller GUI using “https://ip-address.” The default value is enabled. Secure web mode is a secure connection.

Enter "show network summary" and verify.

 

***Please rate all useful responses***

Jagan

 

 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card