I'm wondering if when you set multiple mandatory data rates, example 3, that means a client MUST support these 3 data rates or it has to support one among the 3 mandatory data rates ?
Example, most of our rf profiles 5Ghz Data Rates are configured like this, it's default one (WLC 5520).
Does that mean a 5ghz wifi client must support 6, 12 ad 24Mbps to be able to connect to the AP ? I know the highest mandatory Data Rates is the one used for multicast, but as we use flexconnect mode I think this is not necessary.
If the AP has more than 30 clients connected without a near AP to balance them, does these mandatory Data Rates settings could impact their connections ? Denied or so on ?
For VOIP phones environnement, the data rates recommended is only 12mbps mandatory and above on supported, what is the difference with the default ones and why this configuration ?
You should not have to have more than two max. The lowest mandatory is what the client device must be able to negotiate in order to associate. The highest mandatory rate is also what multicast will prefer, however, it will also allow device to negotiate at a lower rate. So for example, 54mbps mandatory along with 24mbps is a good start if you have good density. I have used higher lower mandatory rates in environments for better roaming.
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 184.108.40.206, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...
This event was scheduled for September 23rd, but it has been moved to November 10 due to complex and unexpected circumstances. We apologize for all the issues this may cause.
Community Live- All Things LTE…4G, 5G and Whatever’s Next
(Live event - formerly...