I have one 2800 AP and one 1815 ap in cisco mobility express mode. I want two SSID where each SSID has their own vlan. I want my network to have vlan 10 and the rental apartment under me to have vlan 5. I have configuered my Cisco 3560 switch with routing and vlan 10 with IP 192.168.10.250 /24. Vlan is configuered with 10.0.0.250/24. Can somebody please help me with what I am missing? My local ISP router have DHCP enabled and gives out IP to managment network wired and wireless but I cannot get the "guest" network to get out on the internet. Thanks for any help!
Here is the switch config:
Vlan5 10.0.0.250 YES manual up up
Vlan10 192.168.10.250 YES NVRAM up up
This is the trunk that goes to the local ISP router I have in my home:
interface GigabitEthernet0/1
switchport trunk native vlan 10
switchport mode trunk
Config to AP
switchport trunk allowed vlan 5,10
switchport trunk native vlan 10
switchport mode trunk
ip route 0.0.0.0 0.0.0.0 192.168.10.1
Gateway of last resort is 192.168.10.1 to network 0.0.0.0
S* 0.0.0.0/0 [1/0] via 192.168.10.1
10.0.0.0/8 is variably subnetted, 2 subnets, 2 masks
C 10.0.0.0/24 is directly connected, Vlan5
L 10.0.0.250/32 is directly connected, Vlan5
192.168.10.0/24 is variably subnetted, 2 subnets, 2 masks
C 192.168.10.0/24 is directly connected, Vlan10
L 192.168.10.250/32 is directly connected, Vlan10
192.168.10.1 is my default gateway from the ISP router. I get vlan 10 to work but I need some pointers on vlan 5 traffic.
My Wlan settings is in Wlan1 and Wlan2 images below. Thanks for the help!
