11-19-2014 05:42 AM - edited 07-05-2021 01:58 AM
Hi Guys,
The " N+1 High Availability Deployment Guide" is pretty straightforward but it is not clear if the only one command necessary on the Secondary Controller is "config redundancy unit secondary".
In AP SSO High Availability , the Backup Controller will get the Configuration from the Primary and it is done. We have a cluster. I am wondering if it does happen the same way for N + 1 HA.
Another point, What happen with I have 2 Primary Controllers with differents setup in terms of WLAN and Virtual Interface ?
11-19-2014 09:15 AM
Hello,
After some researches, my conclusion is that this kind of setup requires identical configuration between Primary and backup WLC, just like redundancy performed prior to 7.4.
I mean, the only advantage for this kind of setup is save mony with license.
11-19-2014 09:29 AM
Exactly. More information regarding N+1 HA guide: Check this post
http://rscciew.wordpress.com/2014/06/07/n1-high-availability-configuration-on-cisco-2504wlc/
Regards
Dont forget to rate helpful posts
11-19-2014 10:11 AM
Thanks. Nice blog.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: