cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
585
Views
10
Helpful
3
Replies

New 5508 WLC

bobjones2
Level 1
Level 1

                   Is it possible to back up a configuration file from a Cisco 2112 WLC and then upload it into a new Cisco 5508 WLC?

3 Replies 3

Damon Garner
Cisco Employee
Cisco Employee

Technically, no. But you can do 'show run-config commands' and will be able to paste it back in line by line, will probably need to add the config command to the beginning of each line. May also have to reorder the commands to get them to take.


Sent from Cisco Technical Support Android App

Saravanan Lakshmanan
Cisco Employee
Cisco Employee

The differences are Physical port config - Lag, AP-Manager interface. So manually config these parameters to 5508. 5508 doesn't use static AP-Manager interface, it uses Management interface for AP management. Lag may be enabled/disabled based on your initial config feed on 5508. If you prefer not to use lag on 5508 then disable lag if enabled already.

Naveen Kumar
Level 4
Level 4

Hello,

According to me ,

No, this is not possible. Because the hardware configuration is different of  both WLC’s.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: