11-23-2010 10:36 PM - edited 07-03-2021 07:27 PM
Anyone setup a 5508 and a Nexus 5548P yet? Anything I should know about, or do I just make the usual port channels?
Regards,
Scott
11-24-2010 12:06 AM
Hi Scott,
nothing special normally. Just make the etherchannel load balancing as "src-dst-ip" and you should be good to go.
Also remember to not put any portchannel negociation, just mode "on".
Nicolas
===
Don't forget to rate answers that you find useful
11-24-2010 07:21 AM
Hey Scott,
Also make sure you use "spanning-tree port type network" on the Nexus side.
11-24-2010 07:23 AM
Thanks Kyle. Is there any guide for connecting to a Nexus, or do I just have to pay attention to the protocols/technologies in use?
Regards,
Scott
11-24-2010 07:26 AM
There's no guide that I know of just pay attention to the same basics as you would for an etherchannel to a 6500 for example with the addtion on the above spanning-tree command and be sure to use "mode on" for the port channel. HTH. Good luck!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: