hi all,
just provisioned 1552 to join on a WLC 2504 8.2.170.
i don't see the mesh tab (see ap-1) after it got registered to WLC.
the other AP (same 1552 platform and OS - ap-2) had the mesh tab and was able to change role to 'mesh'
anything additional i need to do for the 'mesh tab' to appear? is this a bug?
also had DTLS FATAL error and tick/check accept MIC (see pic-3) and 1552 got registered.
is this an AP cert bug (see link below)?
https://bst.cloudapps.cisco.com/bugsearch/bug/CSCur43050
*Nov 13 08:23:50.000: %CAPWAP-5-DTLSREQSEND: DTLS connection request sent peer_ip: 172.27.2.6 peer_port: 5246
*Nov 13 08:23:50.327: %CAPWAP-5-DTLSREQSUCC: DTLS connection created sucessfully peer_ip: 172.27.2.6 peer_port: 5246
*Nov 13 08:23:50.327: %CAPWAP-5-SENDJOIN: sending Join Request to 172.27.206.66
*Nov 13 08:23:50.331: %DTLS-5-ALERT: Received WARNING : Close notify alert from 172.27.2.6
*Nov 13 08:23:50.331: %DTLS-5-SEND_ALERT: Send FATAL : Close notify Alert to 172.27.2.6:5246
*Nov 13 08:23:50.331: AP has SHA2 MIC certificate - Using SHA2 MIC certificate for DTLS.
