Old AP 1240AG

[Cajos1968]

Go myself a couple of APs old 1240AG. When I connect them to POE they boot, but end in flashing ethernet, radio but more conserning the status LED is blinking red amber green. I could not find it any manual. Can someone point me in the right direction?

• I tried a reset, but am not sure if that worked
• I have console connected I see it getting an ip
• I see the ip assigned through BootP
• Can't ping GUI is not up and running (browser)

any thoughts?

[mohanak]

Controller status

Alternating green, red , and amber1

Connecting to the controller. Note If the access point remains in this mode for more than five minutes, the access point is unable to find the controller. Ensure a DHCP server is available or that controller information is configured on the access point.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1240/installation/guide/1240hig5/124h_c4.html#wp1077544

[Prakash Parvathala]

Hi

I think you need to convert your AP from LWAPP (Lightweight Mode) to Autonomous

Refer the below links for conversion

https://supportforums.cisco.com/document/57476/lwapp-autonomous-conversion-and-vice-versa-access-points

https://supportforums.cisco.com/video/11928901/lwapp-lightweight-mode-autonomous-conversion-and-vice-versa

Refer this troubleshooting guide for AP LED blinking issues.

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/1100/installation/guide/110h_c6.html#wp1030793