I have a remote location with 4 AIR-CAP3502E-A-K9 (AP01,AP02, AP03, AP04) ver 2.0 with 8 SSIDs 2 ea. AIR-ANT5135DG-R (DISABLED) and 2 ea. AIR-ANT2422DG-R (ENABLED) I have no b clients and few g clients ( 4 ea. LXE XV6 used very lightly) and a very few N clients (mostly laptops maybe 1 month for 1/2 hr.) I have a 4404 controller ver. 7.0.98.0
AP03 MAC C4:0A:CB:DF:AD:6F Channel 36 (Rate 6,9,12, 18, 24, 36, 48, 54)
AP03 " "6E Channel 36 " "
AP03 " "61 Channel 11 (Rate 2, 5.5, 6, 9, 11, 12, 18, 24, Ext 36, 48, 54)
AP03 " "60 Channel 11 " "
AP03 (MAC 6E)
channel agility: No
Network mode: Infrasture
Preamble: long
#STA#: 0
PCF/DCF: DCF
Cell Power: dBm 17
APO3 (MAC 61)
channel agility: No
Network mode: Infrastruture
Preamble: short
# STA: 0
PCF/DCF: DCF
Cell Power: dBm 20
I have set the radio policy to "all" so it can operate at 2.4 & 5 GHz Range (What should it be set at?)
I have two alerts
1) AP PHY data rate anomaly: user date rates of 48M and 54M is not included in the user defined date rate
2) Missing Performance Options: does not support 802.11b optional capability (/packet-binary-convoltional coding/channel agility)
I'm also showing overlapping legacy BSS condition exists on channels
1) beacon legacy BSS on channel 9 2.4 GHz within range of an HT (20 MHz) AP on channel 13, HT (40 MHz) on channel 13 & HT (40 MHz lower)ch 14
2) " "channel 6 2.4 GHZ " "channel 10 HT (40 Mhz) on channel 10 & HT (40 MHz Lower) ch 14
3) " " channel 1 2.4 GHz " " channel 5 HT (40 Mhz) on channel 13 & HT (40 MHz Lower) ch 9
How do I seperat by operating channels?
Thanks
