Hello friends. I have several AIR-AP1852I-E-K9 and AIR-AP1562E-E-K9 administered centrally in a controller which is configured in one of the AIR-AP1852I-E-K9. Specifically the AIR-AP1562E-E-K9 are attached with two AIR-ANT2547VG-N antennas connected connected at port 1 and 2 respectively.
For the Outdoor AP, they are located in open areas. The biggest challenge is very weak signal transmission. Signals are received within 1Metre from the AP, Beyond that devices does not receive any signal. The channels have been set to Auto selection
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?