cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
Community Live- Understanding How Multicast Works with Cisco
1755
Views
0
Helpful
4
Replies
Highlighted
Beginner

Power Over Ethernet (PoE) not working on WLC 2504

I have connected a 2602 AP to one of the PoE-ports on a 2504 WLC running ver 7.5.102.0. But there's no PoE going to the AP, and it doesn't turn on. There's probably something I have misunderstood here so sorry for asking this stupid question, but why doesn't it work? I checked out controller>ports and all interfaces are there but no PoE.                  

Everyone's tags (3)
4 REPLIES 4
Hall of Fame Master

Re: Power Over Ethernet (PoE) not working on WLC 2504

PoE is not available if you have LAG enabled only if it's disabled.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
VIP Mentor

Re: Power Over Ethernet (PoE) not working on WLC 2504

Scott ,
I think lag not supported on 2504 WLC , is it correct ??

Regards

Sent from Cisco Technical Support iPhone App

Hall of Fame Master

Re: Power Over Ethernet (PoE) not working on WLC 2504

Cisco started supporting LAG on v7.4 which is what a lot of customer wanted. However, PoE gets disabled when LAG is enabled, so it's sort of a trade off.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
VIP Mentor

Re: Power Over Ethernet (PoE) not working on WLC 2504

Hi,
Normally port 3 and 4 are the POE ports on 2504 Wlc.
Check it again if it is right ports.

Regards

Sent from Cisco Technical Support iPhone App

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards