Power Over Ethernet (PoE) not working on WLC 2504

[bvj197222]

I have connected a 2602 AP to one of the PoE-ports on a 2504 WLC running ver 7.5.102.0. But there's no PoE going to the AP, and it doesn't turn on. There's probably something I have misunderstood here so sorry for asking this stupid question, but why doesn't it work? I checked out controller>ports and all interfaces are there but no PoE.                  

[Scott Fella]

PoE is not available if you have LAG enabled only if it's disabled.

Sent from Cisco Technical Support iPhone App

[Sandeep Choudhary]

Scott ,
I think lag not supported on 2504 WLC , is it correct ??

Regards

Sent from Cisco Technical Support iPhone App

[Scott Fella]

Cisco started supporting LAG on v7.4 which is what a lot of customer wanted. However, PoE gets disabled when LAG is enabled, so it's sort of a trade off.

Sent from Cisco Technical Support iPhone App

[Sandeep Choudhary]

Hi,
Normally port 3 and 4 are the POE ports on 2504 Wlc.
Check it again if it is right ports.

Regards

Sent from Cisco Technical Support iPhone App