cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
504
Views
0
Helpful
2
Replies

power requirements for a 1042 mesh network

garyb1965
Level 1
Level 1

this note is from the 5508 controller config manual, does this apply to 1040 access points in a mesh network?

Note:The recommended power source for MAPs is either a power supply or power injector. PoE is not a recommended power source for MAPs.

2 Replies 2

Stephen Rodriguez
Cisco Employee
Cisco Employee

No, that would be about the 15xx series of MESH AP.

Steve

HTH,
Steve

------------------------------------------------------------------------------------------------
Please remember to rate useful posts, and mark questions as answered

thank you much

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: