cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1317
Views
0
Helpful
1
Replies

Problem to Register AP2800 in WLC 8.3.143.0

Hello all, we have a problem with register the AP 2800 into the WLC 8.3.143 the status of the ap is blinking Cycling through Red-Off-Green-Off-Blue-Off we see the ap connected into the switch via cdp.

 

message:  Access point location command invoked from controller web interface.

 

Thanks for you help.

1 Accepted Solution

Accepted Solutions

patoberli
VIP Alumni
VIP Alumni
Can you attach a console cable to the AP and reboot it and show us the output?
It might not get enough power, make sure your Switch supports PoE+ (802.3at).

View solution in original post

1 Reply 1

patoberli
VIP Alumni
VIP Alumni
Can you attach a console cable to the AP and reboot it and show us the output?
It might not get enough power, make sure your Switch supports PoE+ (802.3at).
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: