Problems with 2602i AP not joining WLC

[Lajja1234]

Hi!

I am having a problem where my AP wont join the WLC.

I have solved this problem before by telling the access point where the AP is located. But i cannot remember how the command was.. Anyone have any idea?

/Lajja

[Scott Fella · Accepted solution]

the command is capwap ap controller IP address

Sent from Cisco Technical Support iPhone App

[Lajja1234]

Thank you!

[Scott Fella]

Make sure the time is set properly on the WLC and the country code for the AP is defined in the WLC. You can also place the ap on the same subnet as the WLC manager and have the ap join the WLC. Then after it joins you can move it to another vlan.

Sent from Cisco Technical Support iPhone App

[Scott Fella]

Another command is: test capwap controller IP

Sent from Cisco Technical Support iPhone App

[Abha Jha]

Please find the set of useful capwap CLI config guide..

http://www.cisco.com/en/US/docs/wireless/controller/7.0/command/reference/cli70commands.html#wp12504507