ANNOUNCEMENT - The community will be down for maintenace this Thursday August 13 from 12:00 AM PT to 02:00 AM PT. As a precaution save your work.
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
308
Views
0
Helpful
3
Replies
Highlighted
Beginner

Problems with association of APs in WLC 2504 HA SKU N+1

I have a client that has two wlc 2504. The configuration was made to be in HA SKU N + 1. At the moment of connecting both in the network it is observed that the mobility group looks good and both wlc are seen. But at the time of restarting the primary WLC it is evident that the APs are not associated with the secondary WLC. 

Then an attempt was made to make the roll change, that is, the primary was configured as secondary and the secondary was configured as primary. In this case it was also observed that the mobility group looked good, but the APs were not associated with the primary, they were associated with the secondary, but it was evidenced that they restarted often


What could be the inconvenience for the APs not to associate with the wlc, which could you review, can it be generated by how the wlc have the licenses?

 

I attached a file with the HA configuration 

 

Thank you

Everyone's tags (2)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Master

Re: Problems with association of APs in WLC 2504 HA SKU N+1

If the AP’s don’t associate with one controller, then you probably have an issue somewhere else. Maybe license, NTP, etc. HA definition on the AP works as long as the host name is correct as that is case sensitive also.
-Scott
*** Please rate helpful posts ***

View solution in original post

3 REPLIES 3
Highlighted
VIP Rising star

Re: Problems with association of APs in WLC 2504 HA SKU N+1

easiest way i find to ensure fail over is to configure the APs with a primary and secondary WLC under the AP HA tab.

*****Help out other by using the rating system and marking answered questions as "Answered"*****
*** Please rate helpful posts ***
Highlighted
Beginner

Re: Problems with association of APs in WLC 2504 HA SKU N+1

Hello, 

The configuration over each AP was made before we maked the test. But even configuring both wlc over APs (one primary and other secondary), the APs never associate with one WLC

Highlighted
Hall of Fame Master

Re: Problems with association of APs in WLC 2504 HA SKU N+1

If the AP’s don’t associate with one controller, then you probably have an issue somewhere else. Maybe license, NTP, etc. HA definition on the AP works as long as the host name is correct as that is case sensitive also.
-Scott
*** Please rate helpful posts ***

View solution in original post

Content for Community-Ad