cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
172
Views
10
Helpful
3
Replies
Highlighted
Cisco Employee

"test AAA group xxx username password new-code" always showed the "user rejected"

I would like to test aaa connection in 9800-40 WLC, the software version of WLC is 16.12.03, I used the following command:

 

C9840-2#test aaa group zys-20 zys1 Test12345 new-code
User rejected

 

but it should be passed for authentication in ISE as follow:

I am not sure why it show user rejected, it should be User access. what wrong for this?

Screen Shot 2020-09-14 at 15.24.05.png

3 REPLIES 3
Highlighted
Hall of Fame Master

I did try that also and got the same results and figured that it probably was not yet supported/functional since I didn’t see it referenced in the command reference guide.
-Scott
*** Please rate helpful posts ***
Highlighted

Thanks Scott for help validation again. It looks like ISE can receive the access-request message, but the WLC can’t handle access-accept message from ISE correctly.
Highlighted

Yes you are correct, that is why I believe the feature isn’t available since it’s not in the reference guide. So until they fix/support that command, you will have to figure out another way to test.
-Scott
*** Please rate helpful posts ***