04-11-2012 09:54 AM - edited 07-03-2021 09:58 PM
Hi Cisco Support Community,
I'm trying to modify the power transmission control of multiple Lightweight Access Points (1131 AG E K9) at one single time on WLC 4400 or WCS.
It is effectively possible to configure the power transmission per LAP and in global on WLC 4400 but i need to configure it per group of LAPs =i.e group X of 10 LAPs will have a power Threshold of X -dBm and group Y of 15 LAPs with Y -dBm.
Any help will be much appreciated.
I thank you in advance.
Best Regards,
Pascal.
Solved! Go to Solution.
04-11-2012 10:58 AM
You should be able to create a separate ap template in WCS. One for Group X and another for Group Y. Then you should be able to set the TX power level (not dbm).
Sent from Cisco Technical Support iPhone App
04-11-2012 10:58 AM
You should be able to create a separate ap template in WCS. One for Group X and another for Group Y. Then you should be able to set the TX power level (not dbm).
Sent from Cisco Technical Support iPhone App
04-11-2012 03:35 PM
With 7.2.X, you can create AP Groups and set each AP Group a particular transmission power.
04-16-2012 03:25 AM
Hi Scott Fella and Leolaohoo, I will give a try and keep you posted.
Thanks for the quick respond.
Best Regards,
Pascal
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: