Security penetration alerts in CIsco Prime 2.2

[Abinaya R]

I am using Cisco prime 2.2.0 version
I get lot of Security Penetration alerts and DOS alerts as critical.
I donot want to acknowledge this and Can anyone please let me know what needs 
to be done how to avoid these kind of alerts?

Thanks,

Abi

[sobhardw]

Please refer to the below link :

http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/2-2/administrator/guide/PIAdminBook/maint_network_health.html

[Prakash Parvathala]

Hi Abinaya

Please go through the below link and search for Security Penetration, you can find the causes and solution to stop the same.

http://www.cisco.com/c/en/us/td/docs/wireless/mse/3350/7-4/wIPS_Configuration/Guide/7_4_MSE_wIPS/7_4_MSE_wIPS_appendix_01100.html#ID5

[mohanak]

Threshold (not applicable to all policies)—Indicates the threshold or upper limit associated with the selected policy. Because every policy must contain at least one threshold, default thresholds are defined for each based on standard wireless network issues. Threshold options vary based on the selected policy.

When the threshold is reached for a policy, an alarm is triggered. Alarms from Cisco Adaptive wIPS DoS and security penetration attacks are classified as security alarms. A summary of these attacks is located in the Security Summary page; choose Monitor > Security to access this page. The wIPS attacks are located in the Threats and Attacks section.

– Severity—Indicates the level of severity of the selected policy. Parameters include critical, major, info, and warning. The value of this field might vary depending on the wireless network.

– Notification—Indicates the type of notification associated with the threshold.

– ACL/SSID Group—Indicates the ACL or SSID Group(s) to which this threshold is be applied.

http://www.cisco.com/c/en/us/td/docs/net_mgmt/prime/infrastructure/2-2/user/guide/pi_ug/create_temps.html#pgfId-1101197