Service Port configuration

[ittechk4u1]

Hello Experts,

how can i configure reach my serviec port IP on remote location!

attached is my layout ..

Now i want to access from HQ to service port IP of WLC. how can I reach it by using ssh/https

What and where i need to configure the routes ?

Could anyone help me.

Thanks

[superego]

Hi,

Service port doesn't have a default gateway in its configuration therefore it can be only reached if you are on the same subnet or configure a static route in the WLC - Controller > Network Routes > IPv4 Routes > New.  And you'll need to add route back from HQ to WLC service port subnet if not yet existing.

Please mark helpful posts***

[Leo Laohoo]

Not to be able to access the Service Port DIRECT.
If Plant 1 host the default-gateway for the Service Port subnet, then the only way to get into the Service Port is to remote into Plant 1 and initiate a telnet or SSH from Plant 1 to Service Port.
This is because to configure the Service Port, you only need to provide it with an IP address and subnet mask. Service Port does not have a default-gateway address.
What model is this WLC?

[ittechk4u1]

Thanks.

wlc model is 3504.

Is there no possibility to reach from HQ to standby WLC to service port of Plant 1?

Thanks

[Leo Laohoo]

Not directly, no.