cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2796
Views
0
Helpful
5
Replies

Session Timeout on Mobility Express 8.8

cam0001
Level 1
Level 1

Hello, 

 

I have an AP Aironet 1832i with Mobility Express 8.8 installed, and I can't seem to find the following:

- Session Timeout (https://www.cisco.com/c/en/us/td/docs/wireless/controller/8-8/config-guide/b_cg88/wlan_timeouts.html). It mentions I need to go to "WLANs > Edit > Advanced", but the "Enable Session Timeout" option is not there.

 

- "Client Exclusion Value" (Not found).

- "Client User Idle Timeout" (Not found).

 

I know this might be available to configure through the CLI, but I am not too familiar with it.

Shouldn't this be in the GUI Version?

 

Thanks!

WLAN-AdvancedWLAN-Advanced

5 Replies 5

Scott Fella
Hall of Fame
Hall of Fame
The answer would be, yes, it should be available in the GUI if it is supported. If you are able to configure this from the cli, then you know it’s a possible bug on the code. You can either review the configuration guide on other code version to see if that feature is available or you can open a TAC case and see what they say.
-Scott
*** Please rate helpful posts ***

Here is the configuration guide for Mobility Express. The link you posted is not for Mobility Express but for AireOS WLC.

https://www.cisco.com/c/en/us/td/docs/wireless/access_point/mob_exp/88/user_guide/b_ME_User_Guide_88.html
-Scott
*** Please rate helpful posts ***

Thanks Scott for the reply and the corrected guide. I would think these options should be available in ME on this model, because these are the ones I am missing on my WLANs to comply with the Best Practices review (also in the GUI).

 

I enabled Expert move on ME but still can't find them. I'll keep looking..

 

Carlos

 

0001.jpg

 

 

The best practice is default among all the different platforms, but does not mean it’s available. That being said, the guide doesn’t have the commands so it wouldn’t be available. Cisco should remove features in the best practice if it’s not available because it can be confusing.
-Scott
*** Please rate helpful posts ***

nawir
Level 1
Level 1
Here how to fix your problems
check WLAN ID
(Cisco Controller) >show wlan summary
Number of WLANs.................................. 1
WLAN ID WLAN Profile Name / SSID Status Interface Name
------- ------------------------------------- -------- --------------------
1 STAFF / STAFF Enabled management

disable WLAN first, otherwise we can't change the settings
(Cisco Controller) >config wlan disable 1

disable over-the-ds
(Cisco Controller) >config wlan security ft over-the-ds disable 1

require wmm
(Cisco Controller) >config wlan wmm require 1

set session-timeout
(Cisco Controller) >config wlan session-timeout 1 7200

set user idle timeout
(Cisco Controller) >config wlan usertimeout 1800 1

enable wlan
(Cisco Controller) >config wlan enable 1
save config
(Cisco Controller) >save config

--
Nawir
http://goo.gl/lhQjmU
http://nbctcp.wordpress.com

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: