02-25-2019 01:34 PM - edited 07-05-2021 09:56 AM
I am currently trying to configure an ISR 1111 Cellular Router. I have the config set up, and then went into the AP module so that I can connect it to my WLC that is set up for it.
I made a mistake in the initialization wizard I could not skip and I cannot find a way to change the AP mode from Static to DHCP. This is why I wish to reset the AP to its factory defaults so I can go through the wizard again.
I cannot find anything online that can assist, so any help is appreciated.
Solved! Go to Solution.
02-26-2019 05:57 AM
Unfortunately, it seems as though this model does not recognize wlan-ap0. I did find online:
router#hw-module subslot x/y error-recovery password_reset
It did allow me to get back into the initialization wizard.
02-25-2019 01:40 PM
You can try this:
service-module wlan-ap0 reset default-config
service-module wlan-ap0 reset
Let me know if that works.
02-26-2019 05:57 AM
Unfortunately, it seems as though this model does not recognize wlan-ap0. I did find online:
router#hw-module subslot x/y error-recovery password_reset
It did allow me to get back into the initialization wizard.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: