03-31-2018 04:03 PM - edited 07-05-2021 08:27 AM
Hello everyone: I just made a software upgrade to my controller 2504, I have gone from version 8.0.250, version 8.3.140, previously to a UPGRADE of the FUS 1.9, according to the instructions in the manual.
The process is fine, the WLC is OK and operative, I have reviewed the functionalities before the UPGRADE and they are OK, but there is a problem, when I go to WLANs, then Wlans, this shows me all my WLANs defined and configured, I press any corresponding number to a WLAN ID, and instead of showing me the configuration of the WLAN, it shows me the following:
I have reviewed the RELEASE NOTES of this software version and it does not tell me anything about this topic.
Please, if you can help me.
Regards.
Fernando
Solved! Go to Solution.
03-31-2018 04:12 PM
03-31-2018 04:12 PM
Try different browser
03-31-2018 04:28 PM
Thanks very much, I don´t believe , that the solution was so easy.
Regards.
Fernando.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide