cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
173
Views
0
Helpful
1
Replies
Highlighted
Beginner

Switch a 1562E to use all 4 ports

I'm installing a 1562E with an ANT2513 however I cannot find how to change the AP to use 2.4GHz on ports 1 and 2 then 5GHz on ports 3 and 4 which appears to be a requirement for this antenna. Running 8.5.161 code currently.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Community Legend

  1. Monitor > Access Point Summary section > All APs > Detail link
  2. Find the 1562E of your choice (any other sub-model and this option will not appear) and click on it. 
  3. Go to the Advanced tab.  
  4. Look under "Antenna Band Mode".  

View solution in original post

1 REPLY 1
Highlighted
Hall of Fame Community Legend

  1. Monitor > Access Point Summary section > All APs > Detail link
  2. Find the 1562E of your choice (any other sub-model and this option will not appear) and click on it. 
  3. Go to the Advanced tab.  
  4. Look under "Antenna Band Mode".  

View solution in original post

Content for Community-Ad