Transitioning between 2.4 and 5.0 on the same SSID
Hey everyone, I have this question, does anyone know how much time it typically takes to transition on the same SSID but between 2.4 and 5.0 spectrum?
Essentially i have clients that in certain areas of the floor are associated on the SSID on the 2.4 Spectrum, but when they move around they are associating themselves on the same SSID but on the 5.0 Spectrum, this transition can take up to a minute if not longer,
Question:I have two Cisco 5520 WLC running HA 184.108.40.206 code. Clients (not all) from different places are having difficulties to surf internet on Guest WiFi. Different devices like surface pro, laptops and even phones (both android and phones) is having t...
I have:Product/Model Number : AIR-SAP1602I-E-K9withCisco IOS Software, C1600 Software (AP1G2-K9W7-M), Version 15.3(3)JC, RELEASE SOFTWARE (fc1)I need to have internet access via eth in a deep place of my basement. So I bought a small thing called wifi ext...
I have a few AIR-CAP3502E-A-K9 access points that I want to change to Lightweight mode. I did a lot of researching and found that I needed the ap3g1-k9w7-tar.153-3.JAB.tar file or a similar version of it.I do have that file and I was able to upload ...
WLAN Poller provides functionality to:
Bulk data/debug collection from Controllers and APs. Execute the commands on regular intervals.
DFS statistics and debug collection
IOS AP Flash health check and memory
AP cert check with generating reports
My report tells you a simple viewpoint to understand the evolution of the wireless LAN from 1997 to the 2020s. You can also get basic knowledge on an uplink of Wi-Fi6, the latest IEEE 802.11ax standard. Data analysis results based on our experimental s...