cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

881
Views
0
Helpful
3
Replies

Trunking on 1562D Mesh

I am new to wireless bridging. We have a requirement of point-to-point bridging with 600 meters distance between teh two APs. As we have 1562D LWAPS, so i'm planning to do it RAP-MAP mesh. However, i am not sure if we can allow multiple vlans across the mesh ? If this is feasible, what will be the configuration on switch, rap & map and what is the design constraint I need to take care of ? 

3 ACCEPTED SOLUTIONS

Accepted Solutions
Rising star

Re: Trunking on 1562D Mesh

Highlighted

Re: Trunking on 1562D Mesh

Here is another good resource to look at:

 

https://rscciew.wordpress.com/2014/11/15/wlc-mesh-network-configuration/

 

CJ

Re: Trunking on 1562D Mesh

It worked with "Flex+bridge" mode. I was able to pass on multiple vlans with the bridge blackhaul on native vlan.

3 REPLIES 3
Rising star

Re: Trunking on 1562D Mesh

Highlighted

Re: Trunking on 1562D Mesh

Here is another good resource to look at:

 

https://rscciew.wordpress.com/2014/11/15/wlc-mesh-network-configuration/

 

CJ

Re: Trunking on 1562D Mesh

It worked with "Flex+bridge" mode. I was able to pass on multiple vlans with the bridge blackhaul on native vlan.

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards
This widget could not be displayed.