cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2292
Views
5
Helpful
2
Replies
Highlighted
Beginner

Turn off LED light for 3802i AP in mobility express mode

WLC controller based configuration allows for the ability to turn off the status LED on the WAPs.  After converting the setup to Mobility Express I cannot for the life of me see any way to do it in the GUI (browser) or the CLI.  Any undocumented commands I can run to turn off the LED like I can when the APs are managed by a WLC?

Everyone's tags (1)
1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
VIP Mentor

Hi,

Hi,

Can you try this command on CLI:

config ap led-state { enable | disable} { cisco_ap | all}

Regards

Dont forget to rate helpful posts

View solution in original post

2 REPLIES 2
Highlighted
VIP Mentor

Hi,

Hi,

Can you try this command on CLI:

config ap led-state { enable | disable} { cisco_ap | all}

Regards

Dont forget to rate helpful posts

View solution in original post

Highlighted
Beginner

Thanks Sandeep, that worked. 

Thanks Sandeep, that worked.  The command needs to be issued on the mobility express controller.

CreatePlease to create content
Content for Community-Ad

Cisco COVID-19 Survey