10-02-2019 10:02 PM - edited 07-05-2021 11:04 AM
I am trying to install additional AP license in controller but "Command" option is not showing under Management -> Sofware Activation section to install license also I tried via CLI and getting error " License Installation is blocked by secondary controller"
I have WLC in HA and secondary is Hot standby. Please suggest how I can install the license.
Solved! Go to Solution.
10-03-2019 07:37 AM
- No that's not what I mean, what I mean is to power down the secondary to avoid the initial problem you have when installing the licenses on the primary.
M.
10-03-2019 01:47 AM
- Shut/power-down the secondary , wait a bit , and try this again. If it then works , power-up the secondary. Licensing-capabilities will be synced between the primary and the secondary.
M.
10-03-2019 02:09 AM - edited 10-03-2019 02:09 AM
Thanks for the reply.
You mean if I power down secondary WLC. "command" option under Management -> Software Activation -> Licenses will re appear again?
10-03-2019 02:53 AM
- Basically make sure only the secondary is powered-down, install the licenses, power-up secondary , wait a bit, verify licensing-status afterwards (indeed).
M.
10-03-2019 07:37 AM
- No that's not what I mean, what I mean is to power down the secondary to avoid the initial problem you have when installing the licenses on the primary.
M.
10-03-2019 08:04 AM
I will do that tomorrow and update here in both cases success or faliure.
10-05-2019 11:25 PM
Hi,
Many thanks for your support. Actually, the unit secondary was Active that is why I was not able to install the license however, I kept disconnected the secondary unit during license installation.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: