Unable to take console access of cisco AIR-AP2702I-UXK9 Access point

[sharath.babu9022@gmail.com]

Hi Everyone,

I have three cisco AIR-AP2702I-UXK9 model access points. None of them are responding to the console access.

Same console cable works for 3750 switch and other routers but when connected to the access point they just dont respond.

Just for your information. These access points are lightweight access points, now I need to convert them to autonomous access for that I need console access.

Please advise.

[patoberli]

Make sure you have Flow Control disabled in your console program.
Other settings are Baud Rate 9600, Data bits 8, Parity None, Stop Bits 1.

[Haydn Andrews]

it should work with the lightweight and autonomous APs.