cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1876
Views
0
Helpful
4
Replies

Upgrade Cisco 5508

Hi All,

I am planning to upgrade Cisco WLC 5508 which is currently having Software version 7.5.103.1 and Field recovery software version 7.6.95.16. Latest available software for this device is 8.0.152.0 (AIR-CT5500-K9-8-0-152-0.aes).Is it recommended upgrade to 8.0.152.0 from the existing software Image. Do i need to install Field recovery software in this case. Your support will be highly appreciated.

1 Accepted Solution

Accepted Solutions

 Thanks a lot Leo. 

View solution in original post

4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame
Post the complete output to the command "sh sysinfo".


---------------Show sysinfo---------------

System Information
Manufacturer's Name.............................. Cisco Systems Inc.
Product Name..................................... Cisco Controller
Product Version.................................. 7.5.103.1
Bootloader Version............................... 1.0.20
Field Recovery Image Version..................... 7.6.95.16
Firmware Version................................. FPGA 1.7, Env 1.8, USB console 2.2
Build Type....................................... DATA + WPS

System Name...................................... Makarim-Shorofat-WLC
System Location..................................
System Contact...................................
System ObjectID.................................. 1.3.6.1.4.1.9.1.1069
Redundancy Mode.................................. SSO (Both AP and Client SSO)
IP Address....................................... 10.200.129.243
Last Reset....................................... Power on reset
System Up Time................................... 55 days 16 hrs 23 mins 12 secs
System Timezone Location......................... (GMT +3:00) Baghdad
System Stats Realtime Interval................... 5

--More-- or (q)uit
System Stats Normal Interval..................... 180

Configured Country............................... SA - Saudi Arabia
Operating Environment............................ Commercial (0 to 40 C)
Internal Temp Alarm Limits....................... 0 to 65 C
Internal Temperature............................. +42 C
External Temperature............................. +33 C
Fan Status....................................... OK

State of 802.11b Network......................... Enabled
State of 802.11a Network......................... Enabled
Number of WLANs.................................. 2
Number of Active Clients......................... 35

Burned-in MAC Address............................ 3C:08:F6:CC:EC:80
Power Supply 1................................... Present, OK
Power Supply 2................................... Absent
Maximum number of APs supported.................. 50


@hamzakoleripoyil wrote:

 

Bootloader Version............................... 1.0.20

Bootloader version is fine.  You can upgrade to 8.0.X.X. 

Don't forget to read the Release Notes.

 Thanks a lot Leo. 

Review Cisco Networking products for a $25 gift card