cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
794
Views
0
Helpful
4
Replies

Viewing Trustpoint on Converted 1131 Crashes AP

Scott Pickles
Level 4
Level 4

I converted an 1131 to LWAPP a while back and I'm using it in my lab today.  The controller doesn't accept it since I don't have the SSC hash.  I thought perhaps the command 'show crypto pki <certificate>' would show me the hash of the certificate.  The trouble is that when I run that command, the AP hangs immediately, is unresponsive for 30 - 60 seconds, dumps a crash log, and then reboots.  Any thoughts?

Regards,
Scott

1 Accepted Solution

Accepted Solutions

wackerk24
Level 4
Level 4

Hey Scott, you need to issue debug pm pki enable to get the hash.

View solution in original post

4 Replies 4

wackerk24
Level 4
Level 4

Hey Scott, you need to issue debug pm pki enable to get the hash.

Thanks Kyle!

Scott Pickles
Level 4
Level 4

Upgraded to the latest CAPWAP release and all is well...

I'm curious as to why the hash shown in the debug output differs from that of the output of the command I ran locally on the AP?  It shows 'Fingerprint SHA1' and that's what needs to be entered into the AP policy.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: