I manage a small wireless network that consists of a router, 16 cisco switches, and 28 cisco AIR-CAP1602I WAPs. I am trying to find a way that I can change the Client Authentication Key Management WPA Preshared Key via the command line via a script. I can do this on the switches as well as the router, just cant seem to locate the command for the WAPs.
Is there a way, or cisco IOS command that will allow you to change this?
I can see the below in the running / startup-config file of the WAPs indicating that what I am seeing in the web CLI matches. I can change the Preshared Key in the web CLI interface, however I am looking for the Cisco command that allows me to change that Preshared Key via the command line.
dot11 ssid TEST-AP authentication open authentication key-management wpa version 2 guest-mode wpa-psk ascii 7 073828425A0C0B54043104010D242C02116165734A
[ The link to the discussion will be published on November 10th ]
This event is an opportunity to discuss the LTE market trends from a consumer perspective, highlighting the 4G LTE service from Cisco Enterprise BU. Furthermore, we will discuss the strateg...
Hi All,We have 9100 AP trying to join on 9800 WLC. When AP try to join controller it gives below error Sending Join request to 172.16.31.66 through port 5254Discarding msg CAPWAP_WTP_EVENT_REQUEST(type 9) in CAPWAP state: Join(5)Discarding msg CAPWAP...
Hello, I hope somebody has a solution for the issue I am facing. I have 2 WAP150's, both with firmware 22.214.171.124, and I am not able to save a specific change. Under Wireless > Radio > Advanced Settings > Legacy Rate Sets I can unselect ra...
Hey Guys,I Have several 1600 Series AP's (AIR-CAP1602I-ZK9) that was working with WLC before, I changed them with 1800 series but would like to use 1600 Access Points series independently and without WLC for somewhere else, so I want to know do they...