12-01-2014 07:04 PM - edited 07-05-2021 02:03 AM
looking into a problem at one of my sites with 49 APs (1242s) using WLC 4402 running 7.0.250.0 all channels are on 1, why is this when controlled by the WLC? has the algorithm changed with newer software, please see enclosed for the DCA screenshot, DCA done every 12 hours. Note there is a university next to this site so always had a lot of interference has that got something to do with it?
12-01-2014 07:14 PM
Untick "Avoid Cisco AP load".
Untick "Avoid Persistence Non-Wifi Interference".
12-01-2014 08:23 PM
I think this is a buggy behavior, If you have TAC support reach them & check any known bug ID for this. This is not exact the same, but similar behaviour in CH36 in 5GHz
https://tools.cisco.com/bugsearch/bug/CSCuq36196
Remove the CH1 from DCA list & see AP assign CH6 & CH11. Then readd CH1 to the list.
HTH
Rasika
*** Pls rate all useful responses ***
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide