cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
137
Views
0
Helpful
1
Replies
Highlighted
Beginner

Why can I set the interface for a Wlan in 2 separate places on WLC

On a 5520 WLC

when i create a wlan, i have to assign it to an interface.  

when i create an AP group, then add a wlan to it, I have the ability to assign an interface here was well.  the note on it reads below, but doesn't really apply since i am no using FlexConnect for anything.  

So why can I do this?  What happens if they are set to different interfaces (not really sure I want to test)?  I cannot find any documentation on this.   

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Mentor

Re: Why can I set the interface for a Wlan in 2 separate places on WLC

Interface assign under "AP Group" will take precedence. In that way you can override WLAN map interface to different interfaces based on AP Group.

 

HTH

Rasika

*** Pls rate all useful responses ***

1 REPLY 1
VIP Mentor

Re: Why can I set the interface for a Wlan in 2 separate places on WLC

Interface assign under "AP Group" will take precedence. In that way you can override WLAN map interface to different interfaces based on AP Group.

 

HTH

Rasika

*** Pls rate all useful responses ***

CreatePlease to create content
Content for Community-Ad
August's Community Spotlight Awards