cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
349
Views
0
Helpful
1
Replies

Why wlan using management interface?

SubnetWarrior
Level 1
Level 1

Hi experts!
So i'm learning about my client's WLC, and had some difficulties to understand management interface in wlan.

Why is my client ssid/wlan (named 3cluster) is assigned with managament interface?
This ssid's dhcp is on our core switch interface vlan (int vlan 51), and on that interface vlan there is dhcp relay to my client's dhcp server.

Why don't the ssid/wlan 3cluster is assigned with the interface vlan 51?
Interface with vlan 51 has already in wlc's controller -> interface, but once again, not used by 3cluster ssid/wlan.

The client which is connected to 3cluster ssid has ip address and default gateway with same subnet with interface vlan 51 on core switch.

1 Reply 1

Sandeep Choudhary
VIP Alumni
VIP Alumni

I think your Management interface is in vlan 51 only.

 

Just paste the output the command:

 

show interface detailed management

sh run int <>   --> where wlc mgmt port connecte don swicth

 

Regards

Dont forget to rate helpful posts

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: