cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
267
Views
5
Helpful
3
Replies
Highlighted
Beginner

Wireless Bridge / Mobility Express AIR-AP1542D-B-K9

Dear Team:

 

  I am trying to create wireless Bridge between to sites. The first site is where the RAP (ME Enable) is connected and the second site is where I have connected the MAP (Capwap mode).  I have stablished the link mesh between converting the mesh AP to capwap because I am pretty sure it is the correct workaround.

 

I have followed this document:

 

https://www.cisco.com/c/en/us/support/docs/wireless/mobility-express-aironet-access-points/215077-configuring-point-to-point-mesh-link-wit.html

 

The difference is that I am trying  bridge the traffic from different VLANs however it is not working.

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Beginner

Hi all,

 

  I solved it!

,  I could bridge multiple VLANs over the mesh link. I think that issue was related to a bug on the firmware version 8.10.130.0 (recommended version).  I used the firmware version 8.10.105.0 then I could converted the RAP and MAP ports from access to trunk and passed all the VLANs over there.

 

View solution in original post

3 REPLIES 3
Highlighted
VIP Mentor

Hi,

 

In order to bridge the traffic from different VLANs over the mesh link, VLAN Transparent feature needs to be disabled.

 

Regards

Dont forget to rate helpful posts

Highlighted

Hi Sandeep,

 

 Than you so much for you reply. Yes, before I post this case, I also disabled VLAN Transparent feature.

 

Do you have any other idea?

 

Thanks again!

Highlighted
Beginner

Hi all,

 

  I solved it!

,  I could bridge multiple VLANs over the mesh link. I think that issue was related to a bug on the firmware version 8.10.130.0 (recommended version).  I used the firmware version 8.10.105.0 then I could converted the RAP and MAP ports from access to trunk and passed all the VLANs over there.

 

View solution in original post

Content for Community-Ad