10-15-2020 04:20 AM - edited 07-05-2021 12:38 PM
Dear Team:
I am trying to create wireless Bridge between to sites. The first site is where the RAP (ME Enable) is connected and the second site is where I have connected the MAP (Capwap mode). I have stablished the link mesh between converting the mesh AP to capwap because I am pretty sure it is the correct workaround.
I have followed this document:
The difference is that I am trying bridge the traffic from different VLANs however it is not working.
Solved! Go to Solution.
10-17-2020 04:24 AM
Hi all,
I solved it!
, I could bridge multiple VLANs over the mesh link. I think that issue was related to a bug on the firmware version 8.10.130.0 (recommended version). I used the firmware version 8.10.105.0 then I could converted the RAP and MAP ports from access to trunk and passed all the VLANs over there.
10-15-2020 10:24 AM
Hi,
In order to bridge the traffic from different VLANs over the mesh link, VLAN Transparent feature needs to be disabled.
Regards
Dont forget to rate helpful posts
10-15-2020 12:23 PM
Hi Sandeep,
Than you so much for you reply. Yes, before I post this case, I also disabled VLAN Transparent feature.
Do you have any other idea?
Thanks again!
10-17-2020 04:24 AM
Hi all,
I solved it!
, I could bridge multiple VLANs over the mesh link. I think that issue was related to a bug on the firmware version 8.10.130.0 (recommended version). I used the firmware version 8.10.105.0 then I could converted the RAP and MAP ports from access to trunk and passed all the VLANs over there.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: