cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
597
Views
0
Helpful
1
Replies

wireless bridge using 802.1N technology

nlg-networks123
Level 1
Level 1

Hope you can help me here folks, I have configured a wireless bridge using 2 x AIR-SAP2602E-E-K9 over a distacne of about 80 metres.

This is working well at speeds up to 54Mb, however I was hoping to reach over 200Mb using 802.1N technology, would appreciate guidance on this.

Attached are the configurations - how do I configure to start using 'N' speeds over the wireless bridge?

 

Kind regards

 

Dave Bell

 

1 Reply 1

Use 5GHz (Radio 1) instead of 2.4GHz (Radio 0) to have better throughput. In that band you can bond two 20MHz channel to give higher throughput.

With the current config since you already have WPA2/AES, no additional config required to enable 802.11n data rates.

HTH

Rasika

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: