07-17-2012 11:42 AM - edited 07-03-2021 10:25 PM
I have a client who has all APs on a WiSM 1, and wants to set the WiSM 2 as the secondary controller. Are there any issues with this setup if both controllers are running the same version of code?
Thanks for the input in advance.
Solved! Go to Solution.
07-17-2012 11:58 AM
so long as the code and configs are the same, you should be right as rain
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
07-17-2012 03:08 PM
I have the same setup. Works well.
As what Steve has stated, make sure your code and configs are the same. PLUS make sure that the amount of WAPs failing over to the WiSM-1 doesn't exceed 150 WAPs per controller. Remember the WiSM-1 has TWO controllers and each of the controller can support up to 150 WAPs.
07-17-2012 11:58 AM
so long as the code and configs are the same, you should be right as rain
HTH,
Steve
-----------------------------------------
Please remember to rate useful posts, and mark questions as answered
07-17-2012 03:08 PM
I have the same setup. Works well.
As what Steve has stated, make sure your code and configs are the same. PLUS make sure that the amount of WAPs failing over to the WiSM-1 doesn't exceed 150 WAPs per controller. Remember the WiSM-1 has TWO controllers and each of the controller can support up to 150 WAPs.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: