cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
770
Views
5
Helpful
6
Replies

WLAN design question

scdigital
Level 1
Level 1

Can someone tell me what the best configuration is for the following scenario:

Site1 (Head Office & Data Centre)

100 users

Site2

80 users

Site3

40 users

Site4

40 users

Site5

30 users

Each of the sites has its own Domain Controller.

My idea is to have a vWLC at Site1 and configure AP's in H-REAP/Flexconnect mode at each of the other sites with local switching and radius authentication on the local DC.

Is this a feasible design or is there a better way?

6 Replies 6

Leo Laohoo
Hall of Fame
Hall of Fame

Are you planning to use Catalyst 3850 as your LAN switch at each site?

If you are, then you can use the 3850 to terminate 50 APs at a time and enable the WLC. 

Most switches will be 3560's.

Site 1 will have 4507.

Each site will need less than 5 AP's.

Thanks

Well then, if you will have an authentication server at each site then H-REAP is a very ideal choice.

Scott Fella
Hall of Fame
Hall of Fame

I think the max AP that is supported on a vWLC is 200? You have over 200 AP's.

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***

We have over 200 users, not AP's.  We have around 25 AP's maximum.

Your right;:)

Sent from Cisco Technical Support iPhone App

-Scott
*** Please rate helpful posts ***
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: