cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
55862
Views
10
Helpful
20
Replies
Highlighted
Beginner

Re: WLC 2504 can't access GUI...

I am not sure of how to untagged the management vlan to 0. could you please help me

Highlighted
Hall of Fame Master

Re: WLC 2504 can't access GUI...

To untag the management interface, you set the vlan to 0.
-Scott
*** Please rate helpful posts ***
Highlighted
Beginner

Re: WLC 2504 can't access GUI...

Dear can you sent me configuration comment for untagging the port 1 and vlan ID also I need to change please helo me now I'm standing console with putty for configuration

Re: WLC 2504 can't access GUI...


@Scott Fella wrote:

If your connecting your laptop direct to port 1, then you need to untagged the management vlan. Right now you have that configured for vlan 10, you need to set that to vlan 0.

Then you will be able to ping the management interface and connect to it via the GUI.

Sent from Cisco Technical Support iPhone App


hi scott below in my wlc management interface config:

Interface Name................................... management
MAC Address...................................... bc:c4:93:17:e5:8f
IP Address....................................... 10.150.1.1
IP Netmask....................................... 255.255.255.0
IP Gateway....................................... 10.150.1.254
External NAT IP State............................ Disabled
External NAT IP Address.......................... 0.0.0.0
VLAN............................................. untagged
Quarantine-vlan.................................. 0
Active Physical Port............................. LAG (13)
Primary Physical Port............................ LAG (13)
Backup Physical Port............................. Unconfigured
DHCP Proxy Mode.................................. Global
Primary DHCP Server.............................. 10.150.1.2
Secondary DHCP Server............................ Unconfigured
DHCP Option 82................................... Disabled
IPv4 ACL......................................... Unconfigured
mDNS Profile Name................................ Unconfigured
AP Manager....................................... Yes
Guest Interface.................................. No
L2 Multicast..................................... Enabled

 

 

but i'm still cannot access either ping to management ip address directly through port 1. tq

 

Highlighted
Beginner

Hi i too have same issue and

Hi i too have same issue and found scott answer, 

Could you guide me to configure Service-port configuration on WL C2504.

 

Thanks,

Narpan,

Highlighted
Beginner

Re: Hi i too have same issue and

Dear kddiindia,

WLC service port is used for out of bound management. ip by some reason you are unable to access wlc. you can access wlc by service port ip address and its recommended your service port should different from your management vlan. by default 192.168.1.1 ip address of service port

Regards,
CreatePlease to create content
Content for Community-Ad

This widget could not be displayed.