A customer is performing the ipv6 implementation. the wlc is currently being configured, the ipv6 address was set in the management interface, this ip responds ping from the core, but from another vlan in the network does not respond ping. I would like to know what should be checked in the configuration so that you have an answer from another vlan. additionally verifying the configuration for the APs, you can only put the IP as ipv4 or ipv6, but the documentation says that it works as a dual stack. I would like to know how to configure the part of the APs so that it works as a dual stack and that in the same way towards wireless clients it works ipv6
Yes, the revision of the guide has been done but we have the doubt of the dual stack configuration in the case of APs On the other hand, APs do not use flexconnect, as I see in that case the recommendation is to enable multicast for ipv6, is that correct?
This tool is essentially used to generate some basic configuration for the 9800 Controller. The basic configurations include Day 0 Config, Central and Local Webauth, Dot1x, PSK etc. The tool uses a GUI format to take input variables for the specific use c...
The Workplace, Reimagined: Secure Network Solutions for Business Resiliency
Network Insider Live Webinar
Tuesday, August 18, 202010:00 am Pacific Time(San Francisco, GMT-08:00)
Where and how your employees work is changing—your workforce can...
Do you have hands-on experience with wireless network management?
If yes, please participate in this quick online survey. We'd like to understand your wireless network management and job roles that partake in this task. Your feedback will be reviewed a...
This event had place on Thursday 11, June 2020 at 10hrs PDT
In this session, the Cisco expert covered single image orchestration changes with the Cisco IOS XE Software Release 17.2.1r for Cisco IOS XE and Cisco IOS XE SD-WAN use cases. Duri...
This is a two-step process.
Step 1: Need to add the FlexConnect AP to a FlexConnect Group.Step 2: Need to configure a FlexConnect ACL (to specify the local traffic-of-interest), and map it to that FlexConnect Group.
For step 1----------As in the i...