WLC 5760 - AP2600i failed to join ap-group after reboot
We're deploying a couple of 2600i with an WLC 5760.
We've configured an AP group, named it "factory", and then issued the command ap name AP<ip mac address> ap-groupname factory for both APs. After the restart, both AP were on the AP-Group factory.
The problem is that is we reboot or power off the APs, one will join automatically the AP-Group factory and the other goes to default-group and requires the ap name APAPf872.ead7.31da ap-groupname factoryto join the AP group factory again.
Any suggestion? Is it possible to forced the ap-group configuration directly on the cli of the AP?
QuestionI have the following Air AP:Air-AP1562I-B-K9, 802.11ac outdoor access point There are three antenna cables that go from the inside cover to some soldered connections on a PCB. When removing the cover, two of the soldered antenna connections c...
QuestionHiWe have a guest access set up and was wondering what exactly are the sequence of events from connecting to SSID to being granted internet access, see below steps I'm unsure of are left blank1. connect o SSID through AP2. traffic hits Foreign WLC...
Model:C9120AXI-Q Install EWC on C9120 running with CAPWAP as shown in the attached log, but the installation fails.It looks like you're getting an error like out of storage space.Is there any good way?