01-22-2019 05:16 PM - edited 07-05-2021 09:44 AM
Hi all,
I need to expand a wireless VLAN's subnet from /22 to /20, interface on WLC is not statically referenced in any of the configured WLANs as "Interface/Interface Group(G)" since we use dot1x (via ISE) but it is referenced under one WLAN as "Multicast interface".
I was wondering if the "Changing the Interface parameters causes the WLANs to be temporarily disabled and thus may result in loss of connectivity for some clients" alert applies in this case. Should I expect all wireless clients (in this case they are all 8821 wireless IP Phones) to be disassociated from this WLAN when I change the netmask?
Even if not relevant with the main question, would these IP Phones also reboot as a result of the disassociation (if that's the case)?
Any comment will be appreciated.
Thank you.
Fed
Solved! Go to Solution.
01-22-2019 11:32 PM
Yes clinet will reassociated if you change in dynamic interface configuration.
Regards
Dont forget to rate helpful posts
01-22-2019 11:32 PM
Yes clinet will reassociated if you change in dynamic interface configuration.
Regards
Dont forget to rate helpful posts
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: